Clawfoot Tub Feet Installation

To attach claw or spoon feet to a cast iron tub the female receiver on the bottom of the tub needs to have a keeper to hold the bolt in place they are harder to find than feet that fit only a certain number were made from one mold there were many many different molds and companies. If the foot does not lie flush remove it and install a shim between the foot and mounting pod.

How To Replace Missing Clawfoot Tub Feet

Take foot and place over bolt and gently lower so that the foot rests on both the tub and the tongue and lug The tongue is the flat area that extends back from the foot and consists of the mounting hole for the bolt.

Clawfoot tub feet installation. Place the bars over the threaded studs. Match each tub foot with its corresponding pod as shown below. Cut and remove strapping from around tub 3.

Place the provided metal bars over the threaded studs. Remove foam rim protector 4. These types of tubs can weigh between 250 and 300 pounds depending on if they were built.

Each dovetail bolt will slide into one of the four slotted mounting pods as shown. Take ¾ washer lock washer and place the washer so it is resting on the tongue of the foot. Acrylic Clawfoot Tub Foot Installation Guide 3 5.

Adjust the foot and shim as needed and secure the foot. If the tub is already in place and you need to replace the foot it is going to be VERY difficult to do properly. Once flush there may be a gap of 2mm or less tighten the nuts holding the bar in place.

If the foot lies flush on both sides of the tub and between the foot tongue and lug you can continue to tighten the nut. Remove the washers and nuts from the threaded studs on the bottom of the tub. Acrylic Clawfoot Tub Installation and Care uide 5 Press and Seal Swivel Drain TUB FEET INSTALLATION 1.

Remove plastic wrapping from tub. Carefully lay the tub upside down on towels or other padding so that the bottom of the tub is facing up. Installation for an Acrylic Clawfoot Tub The national US average cost for installing an.

It is normal to have a very small gap between the foot and the tub. Check tub paint and porcelain for any imperfections or damage. ATTACHING THE FEET 1.

Loosely attach the bars to the base of the tub. Dont tighten fully as you will need to adjust later. Take foot and place over bolt and gently lower so that the foot rests on both the tub.

Place a nut over the lock washer and tighten it to within 18 inch of the lock washer. Cast Iron Clawfoot Tub Foot Installation Guide Tools Needed. Set out feet so that the letter on the bottom of the foot corresponds to the letter that is located beside the l ugs on the bottom of the tub.

If your tub is double ended it will only have two. Carefully lay the tub upside down on towels or other padding on the floor so that the bottom of the tub is facing up. Take bolt and insert into the lug so that the threads are pointing towards the ceiling 11.

This will allow you enough space to adjust the foot as needed. That way you do not have to fight gravity to set them in and you have full access to the screws. Place a lock washer over the flat washer.

ATTACHING THE FEET 1. Remove the stud covers and the nuts and washers from the studs on the bottom of the tub 3. They are more suited to two- or three-person teams.

After all feet are attached flip the tub over and allow it to rest on the floor. If the letters on your tub and feet do not. Place your tub upside down on a soft surface.

For more information check out our webs. Clawfoot tub installations are not one-person tasks. Slide the ¾ bolt through all pieces and thread into predrilled hole till hand tight.

In this video we briefly cover how to attach the feet supplied with your Baths of Distinction cast iron clawfoot tub. Tapered rubber shims 4 feet 4 bolts 4 flat washers 4 lock washers 4 nuts. American Standard Clawfoot Tub with tapered wedge and set screw Tub feet are typically first put on with the tub upside down.

Remove the washers and nuts from the threaded studs on the bottom of the tub. CLAWFOOT TUB FOOT CONNECTION 1. Carefully lay the tub upside down on towels or other padding so that the bottom of the tub is facing up.

Lift the tub by the rim only never by the feet. Acrylic Clawfoot Tub Installation Instructions 2 ACRYLIC CLAWFOOT TUB INSTALLATION STEP 1.

How To Best Secure Claw Foot Tub Feet Home Improvement Stack Exchange